News

The grid fill is the result of an extensive optimization of the lath width, the blockage area ratio and the lath layout; The water droplets, splashing on a well drained lath, break in a large number of very small droplets, inducing large heat exchange surface. Blockage area ratio and lozenge layout is the optimized compromise between the pressure drop and the probability of large droplets to hit the laths. The laths height has been selected to transfer the load to the supporting spacers using minimum material quantity. It may be used as well in Counterflow as in Crossflow cooling towers, mechanical or natural draft. It is well adapted to any water quality, even without water treatment, when the fouling risk cannot be determined, in particular with seawater.

Cooling tower fan stack is an essential part of the cooling tower as well as a part of the propeller fan, mitigating pressure loss produced by high input air speed.

Cooling tower fill is one of the most important components for exchange of gas and water in cooling tower. The cooling tower fill is made by the cooling tower PVC sheet. The heat and resistance characteristic of the cooling tower fill are the main factors influencing the cooling efficiency. Moreover the quality of the material will influence the fill's lifetime. LATINO choose the high quality fill for the cooling tower. LATINO'S cooling tower fill is with the advantages of good chemical stability, resistant acid, alkali and organic solvent corrosion, high cooling efficiency, small ventilation resistance, strong hydrophilicity, large contact area etc.

The best selling product in Latino company this month: Cooling tower fill Width: 300 mm or 600 mm Sheet flute: 20 mm Thickness: 0.38 mm before forming or customized Length: customized

Cooling tower fill gluing process is an also very important for the cooling efficency.