News
The fan stack is an essential part of the cooling tower as well as a part of the propeller fan, mitigating pressure loss produced by high input air speed. Fan stacks for cooling towers are made from layered laminated polyester, and they have a double-coat design. Their inner smooth surface allows for the fast removal of air. The outer surface provides high strength and resistance against climatic conditions and the operation of cooling towers. The shape of the classical cylindrical fan stack contributes to lower noise and vibration not only of the fan itself, but the whole cooling tower.
The ABS spray nozzle is also called the hollow cone spray nozzle is available in two diameters and it's used on wood, steel, and fiberglass cooling towers, Natrual draft cooling tower and induced draft cooling tower. The cooling tower nozzle structure allows avoiding the formation of non-irrigated zones in the spray flame and achieving fine-dispersed sprinkling of water in the cooling tower, while the direct-flow shape of the cooling tower nozzle significantly reduces the likelihood of its being clogged with the admixtures in the water.
The fan stack is an essential part of the cooling tower as well as a part of the propeller fan, mitigating pressure loss produced by high input air speed. Fan stacks for cooling towers are made from layered laminated polyester, and they have a double-coat design. Their inner smooth surface allows for the fast removal of air. The outer surface provides high strength and resistance against climatic conditions and the operation of cooling towers. The shape of the classical cylindrical fan stack contributes to lower noise and vibration not only of the fan itself, but the whole cooling tower.
Marley MX75 is a hanging film type that is installed in a crossflow cooling tower. It achieves cooling by spreading water into a thin film over a large vertical surface thereby exposing the water to the maximum amount of air flow.
The fan stack is an essential part of the cooling tower as well as a part of the propeller fan, mitigating pressure loss produced by high input air speed. Fan stacks for cooling towers are made from layered laminated polyester, and they have a double-coat design. Their inner smooth surface allows for the fast removal of air. The outer surface provides high strength and resistance against climatic conditions and the operation of cooling towers. The shape of the classical cylindrical fan stack contributes to lower noise and vibration not only of the fan itself, but the whole cooling tower.
Victory part--Overseas department of Latino company
300 cubic meter of SNCS fill block are loading for shipment. Totally 5 high cube containers. Highlights of packaging : In order to reduce the impact of high temperature in the container during the shipment , we use special heat insulation film to wrap the outside of the cooling tower fill block. In this way, it can prevent the deformation of the fill block.
300 cubic meter of SNCS fill block are ready for shipment. Totally 5 high cube containers. Highlights of packaging : In order to reduce the impact of high temperature in the container during the shipment , we use special heat insulation film to wrap the outside of the cooling tower fill block. In this way, it can prevent the deformation of the fill block.